​ ​ ​ ​ ​ ​ ​ ​ ​ ​ ​ ​ ​
180
Docol 900M
Docol products for automotive

Docol® 900 M

Docol® martensitic steels range from 900-1700 Mpa

This steel has a very high yield strength and an extremely high tensile strength. In addition to its good draw ability and good edge stretching properties; it is also good in welding. A robust and cost effective side impact beam can be made from advanced high strength steel with a strength level of 800 MPa. However for lower weight and improved safety, we recommend a minimum of 1400 MPa. For best weight reduction you should use higher grades with reduced thickness.

Read about all our Martensitic steels.

We supply many steel grades according to standards like EN, VDA and different OEM standards. If you don't find a specific standard in the table below, please contact your nearest SSAB representative for more detailed information.

Dimension Range

Cold rolled / UC, EG: thickness 0.50-2.10 mm, width up to 1527 mm.

Slit strip and cut to length sheets are available upon request.

Grade and coating specific restrictions on available dimensions may occur.

Available Standards

SSAB

Download data sheet

Docol 900M

Docol 900M

USED FOR
STANDARDS
DATA SHEET
USED FOR

Automotive

STANDARDS

SSAB

DATA SHEET

Mechanical Properties
Chemical Composition
Tolerances
Workshop & design
Downloads