SSAB Multisteel PA
Normalized pressure vessel steel heavy plate. SSAB Multisteel PA is hot rolled structural steel for general pressure equipment steel constructions. PA = Pressure American (meets the American standard).
Exceeding the requirements of several standard steel grades, SSAB Multisteel PA is a versatile pressure vessel steel for fabricated pressure equipment made of weldable fine grain steels. Formability and highly consistent quality guarantee fast, uninterrupted production, generating clear savings in the costs of material management. SSAB Multisteel PA exceeds several steel standards and is available as three steel grades: SA/A516 GR 60, SA/A516 GR 65 and SA/A516 GR 70 according to ASME/ASTM SA/A516.
Grade number (ie. GR 70) refers to min tensile strength. SSAB Multisteel PA is made so that we have adjusted tensile strength window so that min value (485 MPa) comes from GR 70 and max value (550 MPa) comes from GR 60. Min yield strength is according to GR 70 (260 MPa).
SSAB Multisteel PA is available in thickness of 6.00 – 90.00 mm (restricted due to reduction rate).
The mechanical properties are tested transverse to the direction of rolling.
|Mind. Aufprallenergie für Längsprüfung,Charpy V 10x10- Kerbschlagversuch|
The test is made longitudinally to the rolling direction in accordance to ASME SA20.
Depending on plate thickness.
|Dicke (mmin)||6.00 - 90.000.236 - 3.543|
Thickness tolerances according to ASME SA20.
Flatness tolerance according to ASME SA20.
Surface according to EN 10163-2 Class B subclass 3.
Shot blasted & primed surface is available upon request.
SSAB Multisteel PA provides two different certificates:
EN 10204-3.1 to SSAB Multisteel PA.
SA-20/2017/A20/2015 to SA516GR60/GR65/70MTLTV.
Weldability is excellent with all welding processes. Increased working temperature requirements are less than those of the corresponding strength grades of standard steels. This means easier welding and cost savings under both workshop and site welding conditions.
Needed working temperatures for thick plates please consult SSAB Tech Support.
SSAB Multisteel offers better formability properties than standard steels. Successful forming requires that the manufacturer uses good workshop techniques. Worn tools, poor lubrication, scratches on the surface of the steel as well as edge burrs will all reduce forming quality.
Guaranteed minimum bending radius for all directions is 2 x t up to 30 mm thick plate where t = plate thickness.
Recommendations for stress relieving and normalizing.
Stress relieving 550 – 600°C (target 580°C)
2 minutes/millimeter of thickness, however, 30 minutes minimum. Slow cooling in the furnace.
Normalizing 900 – 940°C (target 920°C)
1 minute/millimeter of thickness, however, 20 minutes minimum. Cooling in free air.
Informationen bezüglich Schweißbarkeit und Verarbeitung finden Sie in den SSAB Broschüren auf www.ssab.com oder kontaktieren Sie die Technische Kundenbetreuung
Entsprechende Sicherheits- und Gesundheitsvorkehrungen müssen beim Schweißen, Schneiden, Schleifen oder anderen Arbeiten mit dem Produkt getroffen werden.