Bucket design > Bucket types and bucket sizes
How to calculate bucket capacity
Struck capacity is the volume capacity of the bucket after it has been struck at the strike plane. The strike plane passes through the top back edge of the bucket and the cutting edge.
Heaped capacity is the struck capacity plus the volume of excess material heaped on the bucket.
There are two common definitions of heaped capacity:
- The heaped capacity of excavator buckets and backhoes are mostly defined with a 1:1 angle of repose (according to standards ISO 7541, ISO 7546, PCSA 37-26, SAE J296/742b).
- The heaped capacity of loader buckets are defined with a 1:2 angle of repose (according to standards ISO 7541, ISO 7546, PCSA 37-26, SAE J296/742b and CECE V1).
Fill Factor is the percentage of an available heaped capacity of a bucket that is actually used. For example, a fill factor of 80 percent for a bucket means that 20 percent of the rated volume is not being used to carry material. Buckets often have fill factors over 100 percent.
The fill factors are affected by the bucket design, including the bucket penetration, breakout force, rack back angle, bucket profile and ground engaging tools.
In addition, the bulk material itself has a large influence on the fill factor. A stickier material, such as moist loam, forms easier a good heap than dry, poorly blasted rock.
The information in this report is only applicable to SSAB’s products and should not be applied to any other products than original SSAB products.
This report provides general results and recommendations for SSAB steel products. This report is subject to SSAB’s Terms of Use. It shall be the user's responsibility to verify that the information contained herein is correct and is suitable to be used for the particular purpose and application of the user. The report is intended to be used by professional users only who possess adequate expertise, qualification and knowledge for the safe and correct use of the results and recommendations in this report. This report is provided “as is”. The use of the report is at user’s own discretion and risk and that users will be solely responsible for any use of this report. SSAB disclaims any liability for the content or potential errors of this report, including but not limited to warranties and condition of merchantability or fitness for a particular purpose or suitability for individual applications. SSAB shall not be liable for any kind of direct or indirect damages and/or costs related to or arising therefrom, whether special, incidental, consequential or directly or indirectly related to the use of, or the inability to use, the report or the content, information or results included therein.