Strenx® 110 XF
Download data sheet
Download data sheet
Strenx® 110 XF is a cold forming high-strength structural steel. It is a thermomechanically rolled product with a minimum yield strength of 110 ksi. It is suitable for a wide range of structural applications, including equipment and components in the transport, lifting and agriculture industry. Strenx® 110 XF meets the requirements of EN 10149-2 S700MC, ASTM A1011 grade 100 and ASTM A1018 grade 100 and can be supplied according to all of these standards' specifications on request. Strenx® 110 XF is available in thicknesses of 0.079 - 0.393 inches, and in widths up to 63 inches as coil, slit coil and cut to length sheets in lengths up to 630 inches.
The mechanical properties are tested in the transverse direction.
Testing is also performed in the longitudinal direction, according to requirements in EN 10149-2 S700MC and ASTM A1011 grade 100.
1) If ReH is not applicable then Rp0.2 is used.
Impact testing according to EN ISO 148-1 is performed on thicknesses ≥ 6 mm. The specified minimum value corresponds to a full-size specimen.
Valid in both the longitudinal and transverse direction.
Strenx® 110 XF is available with different levels of Si: from max 0.03%, up to max 0.28%. Max Si 0.03% is the standard version that is suitable for hot dip galvanizing with thin Zinc layers, and for products that will not be galvanized. If the material is to be hot-dip galvanized and a thicker Zinc layer is requested, this must be specified at the time of order.
1) Sum of Nb, V and Ti = max 0.22%.
Tolerances according to Strenx® Thickness Guarantees.
Strenx® Guarantees offer considerably narrower thickness tolerances compared to EN 10051.
Width and length tolerances according to SSAB standard.
The SSAB standard offer narrower width and length tolerances compared to EN 10051.
Length tolerances only apply for cut to length sheets.
Tolerances according to EN 10051.
Narrower tolerances according to the SSAB standard are available on request
Tolerances according to Strenx® Flatness Guarantees Class A.
Strenx® Flatness Guarantees offer narrower tolerances compared to EN 10051.
Flatness guarantees only apply for cut to length sheets.
According to EN 10163-2 Class A, Subclass 3.
Thermomechanically Rolled. Strenx® 110 XF is available in as rolled or pickled surface condition with mill or cut edge.
Strenx® 110 XF has good welding, cold forming and cutting performance. Strenx® 110 XF is a cold forming steel not suited for heat treatments at temperatures above 1080°F (580°C) since the material then may lose its guaranteed properties.
For information concerning fabrication, see SSAB´s brochures on www.ssab.com or consult Tech Support.
Appropriate health and safety precautions must be taken when bending, welding, cutting, grinding or otherwise working on the product.