The Strenx® range of high-strength structural steel tubes come in circular, square and rectangular shapes – even customized shapes are available upon request. Strenx® tubes have a superior strength to weight ratio for your high-performing equipment.
Get technical advice
SUITABLE APPLICATIONS
Advanced load-bearing structures in transportation,
lifting and agriculture
TYPE OF PRODUCTS
High-strength hollow sections
AVAILABLE SHAPES
Circular, square and rectangular
Strenx® Tubes are cold formed and welded structural hollow sections with minimum yield strengths of 700 MPa. They come in an extensive range of sizes and wall thicknesses. Use Strenx® Tubes in load-bearing structures to build stronger products that weigh less or to replace mild steel grades. And when you use Strenx®, you’ll get dimensionally consistent, workshop-friendly steel too.
Typical applications for Strenx® Tube 700MLH include load-bearing structures in lifting, material handling, transportation and agriculture, especially in conditions that require extremely high toughness.
Typical applications for Strenx® Tube 900MH include advanced load-bearing structures in the lifting, transportation and agriculture segments.
Typical applications for Strenx® Tube 960MH include advanced load-bearing structures in the lifting, transportation and agriculture segments.
Typical applications for Strenx® Tube 700QLH are load-bearing lattice structures in lifting, material handling, transportation and agriculture, especially in conditions where high toughness is needed.
Typical applications for Strenx® Tube 960QLH are load-bearing lattice structures in lifting, material handling, transportation and agriculture, especially in conditions where high toughness is needed.
Strenx® tubes can be welded using any conventional welding method. MAG welding is the most common technique today, since it is very easy to automate for high productivity
The properties and fine surface finish of Strenx® tubes make it perfect for laser cutting. Thermal cutting of Strenx® tubes is also possible with oxy-fuel flame and plasma. Since tubes are cold formed, they contain residual stresses. Proper design can control distortion when cutting. If distortion becomes a problem the tubes can be stress relief annealed.
Strenx® Tubes can sawed with normal practices Compared to mild steels tubes, saw blade wear can be lower, as the low carbon equivalent prevents the longitudinal weld seam from hardening in the welding process.
Strenx® Tubes and Sections meet or exceed the tolerances of European standards: EN10219 for cold formed welded steel structural hollow sections and EN10210 for hot finished steel structural hollow sections.