ASTM A1018 HSLAS Grade 50

Download data sheet

Select Language

Get datasheet by email
Close

Get datasheet by email

On this page
Show specs in Imperial Metric

General Product Description

ASTM A1018 is a standard specification for hot-rolled, heavy-thickness coils of carbon steel, commercial steel, drawing steel, structural steel, high-strength low-alloy steel and ultra-high strength steel. The specification covers steel coils in thicknesses of 0.230 in. to 1.000 in. A1018 High-Strength Low-Alloy Steel (HSLAS) Grade 50 has a specified minimum yield strength of 50 ksi.

Available Dimensions

Hide/Show specific columns Edit
Select columns to display
    Grade Product type Thickness
    (inmm)
    Width
    (inmm)
    HSLAS Grade 50 Class 1 Coils 0.230 - 0.6255.84 - 15.9 60 - 981500 - 2500
    Compare parameters

    Select one parameter to compare

    Comparison

      Width: Inquire for widths <60 in. down to 39.4 in.

      Mechanical Properties

      Tensile testing is performed in the transverse direction.

      Hide/Show specific columns Edit
      Select columns to display
        Grade Thickness
        (inmm)
        Yield strength
        (min ksi)
        Tensile strength
        (min ksi)
        Elongation in 2"
        (min %)
        Elongation in 8"
        (min %)
        HSLAS Grade 50 Class 1 0.230 - 0.6255.84 - 15.9 50 65 20 16
        Compare parameters

        Select one parameter to compare

        Comparison

          Chemical Composition

          (Heat analysis, wt. %.)

          Hide/Show specific columns Edit
          Select columns to display
            Grade C
            (max %)
            Mn
            (max %)
            P
            (max %)
            S
            (max %)
            Ti 1)
            (min %)
            V 1)
            (min %)
            Cb 1)
            (min %)
            Ni 2)
            (max %)
            Mo 2)
            (max %)
            Cu 2)
            (max %)
            Cr 2)
            (max %)
            HSLAS Grade 50 Class 1 0.23 1.50 0.04 0.04 0.005 0.005 0.005 0.40 0.12 0.40 0.30
            Compare parameters

            Select one parameter to compare

            Comparison

              1) One or more of Cb, V, and Ti may be added. When added the min for that element applies, if not added then there is no minimum requirement.

              2) Production only at “Limits B” for Cu, Ni, Cr, Mo.