ASTM A1011 HSLAS Grade 45

Download data sheet

Select Language

Get datasheet by email
Close

Get datasheet by email

On this page
Show specs in Imperial Metric

General Product Description

ASTM A1011 is a standard specification for hot-rolled, steel sheet and strip and coils of carbon steel, structural steel, high-strength low-alloy steel, high-strength low-alloy steel with improved formability, and ultra-high strength steel. The specification covers steel sheet, strip, and coils in thicknesses less than 0.230 in. A1011 High-Strength Low-Alloy Steel (HSLAS) Grade 45 has a specified minimum yield strength of 45 ksi.

Available Dimensions

Hide/Show specific columns Edit
Select columns to display
    Grade Product type Thickness
    (inmm)
    Width
    (inmm)
    HSLAS Grade 45 Class 1 Coils 0.188 - 0.2294.78 - 5.82 60 - 981500 - 2500
    Compare parameters

    Select one parameter to compare

    Comparison

      Mechanical Properties

      Tensile testing is performed in the longitudinal direction.

      Hide/Show specific columns Edit
      Select columns to display
        Grade Thickness
        (inmm)
        Yield strength
        (min ksi)
        Tensile strength
        (min ksi)
        Elongation in 2"
        (min %)
        HSLAS Grade 45 Class 1 0.188 - 0.2294.78 - 5.82 45 60 25
        Compare parameters

        Select one parameter to compare

        Comparison

          Chemical Composition

          (Heat analysis, wt. %.)

          Hide/Show specific columns Edit
          Select columns to display
            Grade C
            (max %)
            Mn
            (max %)
            P
            (max %)
            S
            (max %)
            Ti 1)
            (min %)
            V 1)
            (min %)
            Cb 1)
            (min %)
            Ni
            (max %)
            Mo
            (max %)
            Cu 2)
            (min %)
            Cr
            (max %)
            HSLAS Grade 45 Class 1 0.22 1.35 0.04 0.04 0.005 0.005 0.005 0.20 0.06 0.20 0.15
            Compare parameters

            Select one parameter to compare

            Comparison

              1) One or more of Cb, V, and Ti may be added. When added the min for that element applies, if not added then there is no minimum requirement.

              2) Copper steel with 0.20% minimum Cu.