CSA 70WT

Download data sheet

Select Language

Get datasheet by email
Close

Get datasheet by email

On this page

General Product Description

General Product Description The Canadian Standards Association (CSA) specification G40.20/G40.21 covers structural quality steel of a number of different product forms. SSAB produces structural quality plates and sheet in accordance with CSA G40.20/G40.21 with specified minimum yield strengths of 38 ksi to 70 ksi. CSA 70WT is a weldable, notch-tough steel with a specified minimum yield strength of 70 ksi for thicknesses up to 2.5 in. along with specified minimum Charpy V-notch impact toughness.

Dimension Range

Hide/Show specific columns Edit
Select columns to display
    Grade Product type Thickness
    (in)
    Width
    (in)
    Length
    (in)
    70WT Plate 0.375 - 0.750 80 - 110 240 - 1020
    Compare parameters

    Select one parameter to compare

    Comparison

      Thickness: Please inquire plate thicknesses greater than the listed maxima.

      Width: Please inquire for plate widths less than 72 in. and inquire plate product over 120 in.

      Length: Please inquire for plate lengths less than 240 in. and for lengths greater than the listed maximum.

      Mechanical Properties

      Tensile testing is performed in the transverse direction. The required tensile properties are tabulated below:

      Hide/Show specific columns Edit
      Select columns to display
        Grade Thickness
        (in)
        Yield strength
        (min ksi)
        Tensile strength
        (ksi)
        Elongation in 2" 1)
        (min %)
        Elongation in 8" 1)
        (min %)
        70WT 0.375 - 0.750 70 85 - 115 14 12
        Compare parameters

        Select one parameter to compare

        Comparison

          1) See elongation requirement adjustment of CSA G40.20-13 (Latest edition).

          Impact Properties

          Impact testing to be completed per CSA G40.21 requirements following Size Group requirements. Actual test temperature may be lower than standard temperature and will be reported with absorbed energy values.

          Hide/Show specific columns Edit
          Select columns to display
            Grade 1) Thickness
            (in)
            Minimum Longitudinal Average Absorbed Energy
            (ft-lbs)
            Test temperature
            (°F) 3)
            50WT Category 1 0.375 - 0.750 20 32
            70WT Category 2 0.375 - 0.750 20 0
            70WT Category 3 0.375 - 0.750 20 -20
            70WT Category 4 0.375 - 0.750 20 -50
            70WT Category 5 2) 0.375 - 0.750
            Compare parameters

            Select one parameter to compare

            Comparison

              1) 70WT must be inquired to determine mandatory Charpy impact testing category and is subject to review before acceptance.

              2) Category 5 must be inquired and is subject to review. Any values other than these shown and/or transverse testing shall be inquired as Category 5.

              3) The tabulated temperatures in the table is the maximum standard longitudinal test temperature.