CSA 70AT

Download data sheet

Select Language

Get datasheet by email
Close

Get datasheet by email

    General Product Description

    General Product Description The Canadian Standards Association (CSA) specification G40.20/G40.21 covers structural quality steel of a number of different product forms. SSAB produces structural quality plates and sheet in accordance with CSA G40.20/G40.21 with specified minimum yield strengths of 38 ksi to 70 ksi. CSA 70AT is a weldable, notch-tough steel with a specified minimum yield strength of 70 ksi for thicknesses up to 2.5 in. along with specified minimum Charpy V-notch impact toughness.

    Dimension Range

    Hide/Show specific columns Edit
    Select columns to display
      Grade Thickness
      (in)
      Width
      (in)
      Length
      (in)
      70AT 0.750 - 1.249 72 - 120 240 - 1176
      70AT 1.250 - 2.00 72 - 120 240 - 1104
      Compare parameters

      Select one parameter to compare

      Comparison

         Width: Please inquire for plate widths less than 72 in. and inquire plate product over 120 in.

        Length: Please inquire for plate lengths less than 240 in. and for lengths greater than the listed maxima. Plate length may be limited by maximum individual plate weight of 66,000 lbs. 

        Mechanical Properties

        Tensile testing is performed in the transverse direction. The required tensile properties are tabulated below:

        Hide/Show specific columns Edit
        Select columns to display
          Grade Thickness
          (in)
          Yield strength 1)
          (min ksi)
          Tensile strength
          (ksi)
          Elongation in 2" 2)
          (min %)
          Elongation in 8" 2)
          (min %)
          70AT 0.750 - 2.00 70 85 - 115 14 12
          Compare parameters

          Select one parameter to compare

          Comparison

            1) Yield strength measured as 0.2% offset or 0.5% extension under load.

            2) See elongation requirement adjustment of CSA G40.20-13 (Latest edition).

            Impact Properties

            Impact testing to be completed per CSA G40.21 requirements following Size Group requirements. Actual test temperature may be lower than standard temperature and will be reported with absorbed energy values.

            Hide/Show specific columns Edit
            Select columns to display
              Grade 1) Thickness
              (in)
              Minimum Longitudinal Average Absorbed Energy
              (ft-lbs)
              Test temperature
              (°F) 3)
              70AT Category 1 0.750 - 2.00 20 32
              70AT Category 2 0.750 - 2.00 20 0
              70AT Category 3 0.750 - 2.00 20 -20
              70AT Category 4 0.750 - 2.00 20 -50
              70AT Category 5 2) 0.750 - 2.00
              Compare parameters

              Select one parameter to compare

              Comparison

                1) 70AT must be inquired to determine mandatory Charpy impact testing category and is subject to review before acceptance.

                2) Category 5 must be inquired and is subject to review. Any values other than these shown and/or transverse testing shall be inquired as Category 5.

                3) The tabulated temperatures in the table is the maximum standard longitudinal test temperature.