ASTM A1011 HSLAS Grade 70

Download data sheet

Select Language

Get datasheet by email
Close

Get datasheet by email

On this page

General Product Description

ASTM A1011 is a standard specification for hot-rolled, steel sheet and strip and coils of carbon steel, structural steel, high-strength low-alloy steel, high-strength low-alloy steel with improved formability, and ultra-high strength steel. The specification covers steel sheet, strip, and coils in thicknesses less than 0.230 in. A1011 High-Strength Low-Alloy Steel (HSLAS) Grade 70 has a specified minimum yield strength of 70 ksi.

Available Dimensions

Hide/Show specific columns Edit
Select columns to display
    Grade Product type Thickness
    (in)
    Width
    (in)
    HSLAS Grade 70 Class 1 Coils 0.188 - 0.229 60 - 98
    Compare parameters

    Select one parameter to compare

    Comparison

      Thickness: Inquire for thicknesses <0.188 in. down to 0.079 in.

      Width: Inquire for widths <60 in. down to 39.4 in.

      Mechanical Properties

      Tensile testing is performed in the longitudinal direction.

      Hide/Show specific columns Edit
      Select columns to display
        Grade Thickness
        (in)
        Yield strength
        (min ksi)
        Tensile strength
        (min ksi)
        Elongation in 2"
        (min %)
        HSLAS Grade 70 Class 1 0.188 - 0.229 70 85 14
        Compare parameters

        Select one parameter to compare

        Comparison

          Chemical Composition

          (Heat analysis, wt. %.)

          Hide/Show specific columns Edit
          Select columns to display
            Grade C
            (max %)
            Mn
            (max %)
            P
            (max %)
            S
            (max %)
            Ti 1)
            (min %)
            V 1)
            (min %)
            Cb 1)
            (min %)
            Ni
            (max %)
            Mo
            (max %)
            Cu 2)
            (min %)
            Cr
            (max %)
            HSLAS Grade 70 Class 1 0.26 1.65 0.04 0.04 0.005 0.005 0.005 0.20 0.16 0.20 0.15
            Compare parameters

            Select one parameter to compare

            Comparison

              1) One or more of Cb, V, and Ti may be added. When added the min for that element applies, if not added then there is no minimum requirement.

              2) Copper steel with 0.20% minimum Cu.